The ITP17’s input can be set up to any of the following signal types:

- current: 0-5 mA, 0-20 mA or 4-20 mA

- voltage: 0-10 V or 2-10 V.

- RTD

- TC

The way you should connect your sensor to the ITP17 depends on the out...

Yes, you can do this without any signal converters.

You can configure the ITP17 in two ways:

- Using the three buttons on the cylindrical body of the ITP17.

- Using our free Akytec Tool Pro software via USB.

Proper device installation (see User Guide) warrants protection against dust and water (IP65 on the front). Because of the exposed terminal block, the rear part of the enclosure is rated much lower – IP20.

Sampling time, max. 1 s

Full-scale accuracy , max.

RTD, U / I signals ± 0,25 %

TC, pyrometers ± 0,5

The ITP17 have three potential groups:

− Power supply 24 V DC

− Analog input

− Digital output


Galvanic isolation from each group to the enclosure is 500 V.

Galvanic isolation between groups is 500 V.

We recommend having this distance as short as possible, because the resistance of a long conductor can affect the measurement accuracy.

The enclosure is only available in black color. The LEDs can be red\green\yellow color.

The device is designed for panel mounting in a borehole of Ø22.5 mm.

Yes, you can do this.

The connection depends on the input signal:

- Current (4-20 mA, 0-5 mA or 0-20 mA) – serial connection; the maximum number of displays depends on the available power, each ITP17 consumes 1W;

- Voltage (0-10 V or...