We already have PD121. PD121 features a flush diaphragm making the device highly suitable for measurements in pasty, viscous, and contaminated liquid media compatible with stainless steel AISI 316L (1.4435) and AISI 304L (1.4307).
It comes with two display options: a 7-inch and a 10-inch TFT LCD, each supporting a resistive touchscreen, 16 million colors, and high contrast for clear visualization in industrial environments.
If the decimal point position has been set to 0, and the current calculated value is, say, 1.7, the display will read 1, i.e. the value will be truncated.
The ITP14’s input can be set up to any of the following signal types:
current: 0-5 mA, 0-20 mA or 4-20 mA
voltage: 0-10 V or 2-10 V.
The way you should connect your sensor to the ITP14 depends on the output signal of this sensor:
You need our programming software ‘akYtec ALP’. It is free of charge. You can find it either on our website or on the USB stick, which is included in the delivery.
Yes, you need a cable (USB A-plug to micro B-plug), which is also include...
Since the ‘CLOCK WEEK’ does not have any inputs you cannot change the parameters of this functional block both from the front panel and through variables.
If you need a modifiable ‘CLOCK WEEK’ in your project, two macros are available in the...
This happens because you are trying to import a macro with an already existing ID, though its name and content are different. Most likely, you created one macro, used the command ‘Export macro’, modified this very same macro, and then exported it...
The program execution time (cycle time) is automatically adjusted based on the program complexity (Auto-Tuning). The automatic adjustment affects the data exchange via Modbus since program execution takes higher priority over processing requests. If ...
When the SD LED stops blinking and turns to constant green, the data start being temporarily stored in a 16 kB buffer. One minute later or when the buffer is full, the SD LED turns back to blinking, indicating that the data have started transferring ...
To program the MSD200, you need the ‘MSD200 Configurator’ from akYtec. It is free of charge. You can find it either or on our website or on the USB Stick that is included in the delivery.
For the connection of the MSD200 to a PC, a USB C...
Yes, you should do that according to the measuring range of the sensor.
For example, to log temperature using a DTS125L PT100 and an NPT1 that is connected to a 4-20 mA input of the MSD200, take the following configuration:
Yes, you can monitor them in real time on the tab ‘View Data’ in the ‘MSD200 Configurator’ if the MDS200 operates as Master.
If the MSD200 operates as Salve, you cannot view Modbus registers in real time. In this case, the ...
If you need to process only standard current signals of 4-20 mA, 0-20 mA, 0-5 mA, or voltage signal of 0-10 V, it is better to give your preference to the MV110-24.8AS input module taking advantage in sampling time of its inputs.
In other cases, suc...
1. User Guide
As it says in User Guide (UG) on page 16 of device :
“In case of an input error, the error code is written in the most significant byte of the corresponding AIn REAL register instead of the measured value.”
So for example...
Without using repeaters, up to 32 modules can be connected to one RS485 interface, the length of the communication line between the devices must not exceed 1200 metres.
It has two discrete outputs, DO1A and DO1C, with a shared common output, DO1B).
DO1A is normally open, meaning it remains open under normal operating conditions and closes when protection is tripped. Conversely, DO1C is normally closed, meaning it...
