The lifetime is 8 years, and the MTBF is 80,000 hours.

If the decimal point position has been set to 0, and the current calculated value is, say, 1.7, the display will read 1, i.e. the value will be truncated.

The ITP11 supports any 4-20 mA signal from any piece of equipment with an output of this kind. The connection should be performed in series.

That depends on the output, whether it is a passive or an active one. For example, the analog outputs of our Programmable Relay PR200 are passive outputs, meaning that any of them requires an external voltage source. In case of an active analog outpu...

The number of the connected displays depends on the available supply voltage because each ITP11 causes a voltage drop of about 4 V. For example, an external voltage source of 24 V connected to a 4-20mA analog output of a Programmable Relay PR200 supp...

First of all, check the polarity of the signal.
Also, make sure that the 4-20 mA signal is available. If the signal is too low (< 3.8 mA), there is not enough power to switch on the process display.
Check the wiring. A wire may be loose or not c...

No, you cannot do it. The ITP11 supports only 4-20 mA.
For a 0-10 V signal, you can use our Universal Process Indicator ITP14.
For a Pt100 signal and many other signals for temperature measurement, we offer the Temperature Display ITP16.
Please fe...

The ITP11 doesn’t require auxiliary power and is supplied directly from the current loop.

You don’t need any software to program the ITP11. The programming is carried out by using three buttons on the ITP11’s cylindrical body.
Please, watch our video tutorial ‘ITP11 Process display 4-20 mA. First Start’ to get mor...

To scale the measuring limits, please proceed as follows:
- Connect the device to a 4-20 mA signal to provide power.
- Hold down the PROG button for at least 3 seconds to access the parameter menu.
- When the display shows ‘0’, enter t...