JavaScript seems to be disabled in your browser.
You must have JavaScript enabled in your browser to utilize the functionality of this website.

akYtec |
Faq |
DATA LOGGERS

DATA LOGGERS

MSD200

or search frequently asked questions:

When I lever the ARCH DIP switch in the ON position, the SD LED starts blinking green, i.e. the logging has begun. The blinking stops a few seconds later, and the LED remains green. Why does the MSD200 stop recording to the SD card, and how can I solve this matter?

What software do I need to program the MSD200? Do I need a specialized cable? Is this cable and an SD Card included on the delivery?

Can I scale an analog input signal with the ‘MSD200 Configurator’?

Can I monitor Modbus registers and analog inputs in real time?

If there is a power loss on the MSD200, does the system restart with the set configuration in memory?

I have installed the software and driver for the device. When I tried to connect to it, it keeps coming back with errors and cannot connect. What should I check?

Do you have a short start guide that describes the startup of the MSD200 step by step using an example?

How can I get the log file from the MSD200?

Is it possible to connect a 4-20 mA signal in series with the MSD200 and a control system to log the signal information?

Can I use the MSD200 to open/close a valve depending on the 4-20 mA signal to be logged?

How many Modbus Registers can be logged with the MSD200?

What register addressing does the MSD200 use, decimal or hexadecimal?

I have connected a Slave Device to the MSD200. I am having problems reading INT and REAL variables. I check a value on the View Data tab, but the value doesn’t make sense. What should I check?

How should I configure an analog input of the MSD200? Is it necessary to connect a shunt resistor to the input?

Back to All Topics