Without using repeaters, up to 32 modules can be connected to one RS485 interface, the length of the communication line between the devices must not exceed 1200 metres.

The modules are compatible with third-party PLCs if the PLC supports ModBus RTU or ASCII protocols.

To configure the module you will need the RS485-USB interface converter IC4-M as well as the M110 Configurator software.

It is necessary to set the "Factory settings" jumper in the module (its location can be found in the module's manual). After that in the Configurator it is necessary to select "Factory settings".

Yes, terminal block for I/O connections is removable and enables quick and easy replacement of the device.

Some devices from Mx110 product line have galvanic isolation, which is performed differently for each model and in groups, such as power supply, inputs/outputs, interfaces and housing.

No, this voltage source cannot be used to feed a Mx110 module because it doesn’t provide enough current (max. 100 mA).

The register address has to be written in decimal.

Modbus registers are typically 16-bit values, used to store and exchange various types of data, such as sensor readings, control parameters, status information, etc. These registers are represented in a hexadecimal format and organized in a range fro...