TEMPERATURE CONTROLLERS

Yes, the 2TCR1 supports a wide range of standardized analog signals:

Current signals: 0–5 mA, 0–20 mA, 4–20 mA
Voltage signals: 0–5 V, 0–10 V

It also supports a broad range of RTD and TC (thermocouple) sensors.

The 2TCR1 does not have a built-in data logging function. For this purpose, it is recommended to use external devices such as the Akytec MSD200 module, which can archive data via the RS-485 network.

With the Akytec Tool Pro software, you can configure the following:

Operating modes of logic units (LU): comparator, P-controller, data logger
Types of input signals
Temperature setpoints and hysteresis
Alarm and fault parameters
Display setti...

The 2TCR1 supports the standard Modbus ASCII/RTU protocol via the RS-485 interface, ensuring easy integration into SCADA systems and dispatching networks.

For thermocouples (TC): accuracy is ±0.5%.
For other sensors: accuracy is ±0.25%.

For configuring the 2TCR1, it is recommended to use the Akytec Tool Pro software, which is compatible with Windows operating systems. The software provides an intuitive interface for device configuration, monitoring, and firmware updates.

The 2TCR1 has an IP54 enclosure rating for versions P1 and P2, providing protection against dust and water splashes.

The 2TCR1 supports the following operating modes:

Two-position (relay) mode: Control of the actuator with two states (on/off).
Three-position mode: Regulation with two setpoints and two actuators.
Analog P-control: Proportional control using ana...