Yes, the ITP11 is designed to work with a loop powered pressure transmitter operating in a 4–20 mA current loop. It receives power directly from the loop, eliminating the need for an additional power source, making it ideal for industrial applicati...

Technically, it doesn't matter; but in terms of convenience, it depends on your particular case.

The lower measuring limit (the parameter di.Lo) should be set to 0.
The upper measuring limit (the parameter di.Hi) should be set to 100.

The alarm function makes the display blink with a frequency of about 2 Hz when the output is switched on.
To use this function properly, please proceed as follows:

- Connect the device to a 24 VDC power supply
- Access the parameter menu: Hol...

Proper device installation (see User Guide) warrants protection against dust and water (IP65 on the front). Because of the exposed terminal block, the rear part of the enclosure is rated much lower – IP20.

The enclosure is only available in grey color. The LEDs of loop powered process indicator
can be ordered in red or in green color.

The ITP14 or the ITP14, each of them has three potential groups:

− Power supply 24 V DC
− Analog input
− Digital output

Galvanic isolation from each group to the enclosure is 500 V.
Galvanic isolation between groups is 500 ...

The 4 20ma indicator is designed for panel mounting in a borehole of Ø22.5 mm (see User Guide, Appendix A).

The ePLAN 3D model is available under the tab ‘DOCUMENTS AND SOFTWARE’ on the product page. There is also a STEP model available under the same tab.